Build date: July 03, 2023.

Lot name changed for marketing reasons.

⚠️ This firmware is fully compatible with HUANANZHI X99-TF motherboard, but is a firmware for X99-F8.

Firmware for all modifications of HUANANZHI X99-F8 / X99-TF motherboards using the Intel C612 Chipset.

Supported Flash chips in VSCC table: EF4018 (Winbond W25Q128), EF6018 (Winbond W25Q128), C22018 (Macronix MX25L128), 20BA18 (Micron N25Q128), C84018 (GigaDevice GD25x128).

Supported various Realtek ALC HD Audio Codec.

Supported all known DDR4 memory types like UDIMM, RDIMM, LRDIMM, ECC works.

Maximum tested with four LRDIMM DDR4-2400 128Gb (512Gb) with an Intel Xeon E5-2680V4 processor.

RDIMMs offer larger capacities than UDIMMs and include address parity protection. LRDIMMs support higher densities than single- and dual-rank RDIMMs, and higher speeds than quad-rank RDIMMs. This support enables you to install more high capacity DIMMs, resulting in higher system capacities and higher bandwidth.

Differs in components using nuvoTon NCT5532D or nuvoTon NCT5567D-B.

Please select your firmware version after purchase and follow the instructions.

Firmware features:

UEFI Only / Legacy Mode Not Supported.

Set FSB to 100 MHz.

ME firmware to v9.1.45.3000 (5MiB).

EFI/OROM for Intel VROC SATA(Port 0-3)/sSATA(Port 4-7) to v6.2.0.1034 (Full I/O speed).

Latest CPU microcode.

AMI NVMe firmware.

LAN BOOT ROM.

EFI Realtek UNDI PCIe GbE Family Controller Driver v2.056.

DMI Data.

Looked:

MBEx, Cipher Transport Layer TLS (CVE-2017-5689 & CVE-2018-3616), PTT, NFC, RPAT, AMT.

Special features:

Ready to enable Resizable BAR (from GitHub github.com/xCuri0).

EFI Shell v2.40.

Enable DUAL/QUAD SPI for Winbond 25Q128FVSG & 25Q128JVSQ.

Production Master Access.

Increased BBBS up to 1MiB.

WCOD ID 0x0082 TAYLOR.

HOW TO UPDATE THE FIRMWARE

⚠️ If you have factory stock firmware - YOU MUST USE A PROGRAMMER DEVICE! (e.g. EZP-2019 or CH341A)

Burn the firmware with a programmer device. (e.g. EZP-2019 or CH341A)

Clear CMOS by plugging motherboard power cables and removing the CMOS battery for a few seconds then plug again.

After restart load setup default by entering the BIOS setting and then Restore Defaults -> F10 -> Enter

Configure RAM timings and other settings and enjoy!

제작자 : BIOS I-Enginner

유료로 구매한 X99-TF (or F8) 최신 바이오스입니다.

잘사용하세요.

ALC - 꽃게텍 사운드 코덱

Rebar - Resizeble BAR

BARALC - Resizeble BAR + 꽃게텍 사운드코덱