In your BIOS, your SATA controller has selectable modes of operation. Typically these are:
IDE - In this context, it simply means to use 'legacy' ATA operation mode. It can also be referred to as 'IDE emulation', which itself is misleading, as explained earlier, all SATA drives are themselves IDE devices. For using multiple independent drives, this mode of operation can be selected. Note there is no performance 'loss' using this.
RAID - This sets the SATA controller to operate in RAID mode. This is where you would use multiple drives as one single storage 'array'.
AHCI (where supported) - This sets the SATA controller to operate in AHCI mode. It provides 'hot-swapping' facilities, as well as Native Command Queuing will improve the performance.
In your BIOS, your SATA controller has selectable modes of operation. Typically these are:
IDE - In this context, it simply means to use 'legacy' ATA operation mode. It can also be referred to as 'IDE emulation', which itself is misleading, as explained earlier, all SATA drives are themselves IDE devices. For using multiple independent drives, this mode of operation can be selected. Note there is no performance 'loss' using this.
RAID - This sets the SATA controller to operate in RAID mode. This is where you would use multiple drives as one single storage 'array'.
AHCI (where supported) - This sets the SATA controller to operate in AHCI mode. It provides 'hot-swapping' facilities, as well as Native Command Queuing will improve the performance.
그 외의 내용도 필요하실듯하니
나머지 부분도 읽어보세요~~^^
햔국어판은 다른분께 패스....^^
보통은 이렇게 얘기해요.
ide는 레거시 모드
ahci는 ahci 모드
raid는 레이드 모드
위 내용으로 위치 검색해 보셔도 됩니다..^^
예시)
https://ko.m.wikipedia.org/wiki/%EA%B3%A0%EA%B8%89_%ED%98%B8%EC%8A%A4%ED%8A%B8_%EC%BB%A8%ED%8A%B8%EB%A1%A4%EB%9F%AC_%EC%9D%B8%ED%84%B0%ED%8E%98%EC%9D%B4%EC%8A%A4
쉽게 설명드리면
레이드의 경우는 두개의 하드 모두 ahci 드라이버가 이미 있었기 때문에
모드를 바꾸셨어도 부팅이 가능했던 것입니다.
물론... 이종간에는 안전모드 부팅후 레지변경 및 드라이버를 올려주어도 됩니다.
AHCI가 요즘 사용하는 SATA 방식이구요.
이걸로 해놔야 속도도 제대로 나오고, hot plug도 지원됩니다.
RAID모드는 SATA방식의 HDD를 여러개 묶어서 더 큰용량으로 사용할수 있도록 해주는 모드입니다.
보통은 AHCI 모드로 설정하여 사용하면 됩니다.