메인보드는 p5k se 입니다.

PCIe Gigabit LAN controller featuring AI NET 2

ATHEROS Attansic L1, 10/100/1000 Mbps 이더넷

라고 나오는데...

xpenology에 ssh 로 접속해서 확인 하니 이렇게 나옵니다.

c****@xpe01:/$ ethtool -i eth0
driver: atl1
version: 2.1.3
firmware-version:
bus-info: 0000:02:00.0
supports-statistics: yes
supports-test: no
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: no

맞게 잡혀있는지 조언 부탁드립니다.

c***@xpe01:/$ ethtool eth0
Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supported pause frame use: No
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Advertised pause frame use: No
        Advertised auto-negotiation: Yes
        Speed: 1000Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        MDI-X: Unknown
Cannot get wake-on-lan settings: Operation not permitted
        Current message level: 0x0000003f (63)
                               drv probe link timer ifdown ifup
        Link detected: yes